Everyday Systems · Objects & appliances
Washing machines and dishwashers
Both machines clean with water, heat, detergent, movement and time. Follow a cycle from fill to spin, see why eco programs take longer but use less energy and how the machines changed housework.

What you will learn
- Describe the stages of a wash cycle and the part that does each
- Explain how a front-loader and a top-loader move clothes through water
- Explain how chemistry, heat, movement and time trade off in cleaning
- Explain why an eco program runs longer but uses less energy
Lesson 1 of 4 · 4 min
What happens inside a washing machine cycle
Press start and the machine runs a script. A controller opens valves, switches heaters and pumps, and turns the drum at different speeds. The steps are almost always the same.
First, valves fill the drum with water. Many European machines take only cold water and warm it with their own heating element. Next comes the wash, when the drum or a central paddle moves the clothes through soapy water. A pump then drains the dirty water.
Then come several rinses with clean water to carry away the detergent. Finally the drum spins fast to fling water out through its holes. Early machines spun at about 300 turns a minute. Most now spin at 1,000 to 1,600. Faster spinning leaves less water to dry off, but it creases clothes more and wears the bearings.
Machines move clothes in two different ways. A front-loader has a drum on its side with paddles on the inner wall. As the drum rocks back and forth, the paddles lift the clothes and drop them. Each fall flexes the fabric and squeezes soapy water through it.
Because the clothes only need to be wet, a front-loader uses little water. It fills to a low level, waits while the dry clothes soak it up, then tops up.
A classic American top-loader works differently. A finned post in the middle, the agitator, twists one way and then the other. It pushes water out to the sides, up and back down in a loop, dragging the clothes along. For that to work, the clothes must float freely, so the tub has to be full of water.
Try to recallWhy does a front-loading washing machine need less water than a top-loader with an agitator?
A front-loader cleans by lifting and dropping clothes, which flexes the fabric and pushes water through it, so the clothes only need to be wet. A top-loader's agitator drives water in a loop that drags the clothes along. That only works if the clothes float freely, so the tub must be filled.
A wash cycle runs fill, wash, drain, rinse and spin under a controller. A front-loader cleans by dropping wet clothes, so it needs far less water than a top-loader that swirls them.
Lessons in this topic
What happens inside a washing machine cycle
Follow a load from fill to spin, meet the part that runs each stage and see how a front-loader cleans with so little water.
Why the eco program takes so long
Learn the four things that do the cleaning and see how a long, cool program swaps heat for time to save energy.
How a dishwasher cleans, and whether it beats the sink
See what the spray arms, salt and rinse aid do inside a dishwasher, then what a test of 113 hand-washers found against the machine.
Laundry before the machine, and what machines changed
See what a wash day involved by hand, how dryers and clotheslines compare, and why historians argue over whether machines cut housework.
Three quick stories from this topic
Hand-washers left dishes dirty
In a lab test, about half of hand-washers left dishes too dirty for a dinner table
University of Bonn researchers had 113 people wash 12 place settings as they would at home. They averaged 103 liters of water and 79 minutes, while a modern dishwasher used about 15 liters and cleaned better.
Wide differences
One person used 447 liters, and using more energy barely improved how clean the dishes got.
How the machine wins
A dishwasher sprays a small amount of hot water from spinning arms instead of running a tap.
Wash cycles got longer
Australian front-loader wash cycles grew from 99 to 144 minutes in ten years
The figures cover a 3.5 kg load, including rinsing and spinning, from 2011 to 2021. Longer, cooler programs save energy, because heating water is most of what a washing machine uses.
Time for heat
Detergent, heat, movement and time trade off, so a cooler wash can clean as well if it runs longer.
Written into law
Since 2021, EU machines must offer an eco 40-60 program, and manuals must say long, cool programs usually use the least energy.
The right to dry
Some American neighborhoods ban hanging laundry outside to dry
Homeowners' associations in parts of the United States forbid outdoor clotheslines or hide them from the street. Campaigners call their fight a right to dry, since line drying uses no energy at all.
Dryer country
About 80% of American households own a clothes dryer, against 40% in Germany and 30% in South Korea.
What a load costs
A condenser dryer uses about 2 kWh per load, and a heat pump dryer under half that.
Sources
- Washing machine, Wikipedia
- A European Comparison of Cleaning Dishes by Hand (Stamminger et al., EEDAL 2003), University of Bonn, archived copy
- Laundry, Wikipedia
- Clothes line, Wikipedia





